Clamp In
Push Barry's main clamp down over the lip of your wheelbarrow and screw in the large hand-bolt to lock it in place. No tools needed.
Stop wrestling your wheelbarrow onto the roof rack. Barry clamps into your tow hitch and carries it for you — loaded in under a minute, no lifting over your head.
Too big for the tray. Too awkward for the roof rack. Every job starts with ten minutes of Tetris and ends with a strained back. Barry gets it out of the way — off your tray, off your roof, onto your hitch.
Push Barry's main clamp down over the lip of your wheelbarrow and screw in the large hand-bolt to lock it in place. No tools needed.
Drop in the pin and R-clip to lock it off, throw the included rated tie-down strap over, and you're on your way.
Answer two questions. That's the whole checklist.
1 — Does your vehicle (or trailer) have a 2-inch tow hitch receiver?
2 — Is your wheelbarrow square-fronted?
Barry fits. Easy. A standard 2-inch receiver and a standard barrow is all it takes. Three length settings let you manage rear overhang.
Worth checking first. Barry is built for a standard 2-inch tow hitch receiver. If you haven't got one, most towbar fitters can install one — and if you're not sure what size yours is, send us a photo and we'll tell you straight.
Check your barrow first. Square-fronted barrows may not slot into Barry's lower cradle depending on size. Send us a photo of your barrow and we'll confirm before you buy.
You're almost certainly good. If your barrow has a standard rounded front lip, Barry fits. Not sure? Send us a photo and we'll confirm.
★★★★★"Works amazing. Great people to deal with as well."
Brendon
★★★★★"We purchased a tow hitch extension and it's worked out a treat for us. Here's a photo of Barry in action!"
Kenneth
★★★★★"My husband is very happy with it. It has definitely made his life easier and would recommend to everyone."
Kristy
★★★★★"Such a great product — we have already done a few bog laps through the Bunnings car park to make the other tradies jealous."
Wayne
Gavin has been a tradesman for 37 years and a registered builder for 21 of them. Decades of 4am starts and 40-degree days taught him one thing: spend your energy on the craft, not on battling a barrow onto a roof rack.
Barry is his answer — a dedicated tie-off point for the trade's most awkward, most essential tool. Designed on the job, by someone who uses it every day.
— Gavin
$279
$328.50$299
Barry holds barrows of all sizes. The only exception is square-fronted barrows, which depending on size may not slot into Barry's lower cradle.
Barry will cover most centrally-mounted number plates. That's exactly why we offer the Auxiliary Plate Holder — grab the Complete Kit and source an auxiliary plate from your state or territory's transport department, and you're road-legal.
Yes — with a 2-inch auxiliary hitch receiver. Check your state or territory's vehicle equipment regulations to make sure you comply.
Barry is designed for a standard 2-inch tow hitch receiver — ute, van, car or 4WD. If your towbar has a smaller receiver, Barry won't fit as supplied. Not sure what size yours is? Send us a photo and we'll confirm before you buy.
We stand by the quality of our products. If you're not happy for any reason, we offer a 30-day money-back guarantee.